EX-4200
From JuniperClue
On this page there are some pictures and some CLI info on the EX-4200:
Pictures
Front view:
Ethernet Ports:
Rear fan tray + Virtual Chasis connector slots
Power supply slots:
Please note that it seems you cannot swap a power supply from another running switch as the second power supply has a screw down while the first power supply has a screw up :(
The hotswapable fan tray:
The power supply:
Inside the power supply slot in the switch:
Virtual Chasis connecting cable:
On the cable there says PCI-e x8
Inside the front UpLink port slot (you can see how the connector looks like):
2 EX4200 connected together as a Virtual Chasis:
Two switches powered on:
CLI info
root@ex4200-1# run show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Temperature 34 degrees C / 93 degrees F
DRAM 1024 MB
Memory utilization 24 percent
CPU utilization:
User 9 percent
Kernel 2 percent
Interrupt 0 percent
Idle 89 percent
Model EX4200-24T, 8 POE
Serial ID XXXXXXXXXX
Start time 2008-05-10 18:35:29 EEST
Uptime 10 hours, 49 minutes, 4 seconds
Load averages: 1 minute 5 minute 15 minute
0.06 0.10 0.13
Routing Engine status:
Slot 1:
Current state Backup
Temperature 42 degrees C / 107 degrees F
DRAM 1024 MB
Memory utilization 24 percent
CPU utilization:
User 8 percent
Kernel 1 percent
Interrupt 0 percent
Idle 91 percent
Model EX4200-24T, 8 POE
Serial ID XXXXXXXXXX
Start time 2008-05-10 18:45:26 EEST
Uptime 10 hours, 39 minutes, 7 seconds
Load averages: 1 minute 5 minute 15 minute
0.02 0.06 0.07
root@ex4200-1# run show virtual-chassis status
Virtual Chassis ID: 0019.e251.9d00
Mastership Neighbor List
Member ID Status Serial No Model priority Role ID Interface
0 (FPC 0) Prsnt XXXXXXXXXXX ex4200-24t 128 Master* 1 vcp-0
1 vcp-1
1 (FPC 1) Prsnt XXXXXXXXXXX ex4200-24t 128 Backup 0 vcp-0
0 vcp-1
Member ID for next new member: 2 (FPC 2)
Categories: Hardware | EX-series | Stub

















